If the host is connected to less than eight (8) paths, additional sessions can be configured going to the same target ports.ĩ. A session is normally created for every target port where a host is connected. Now the new host, Server01, is connected to the new volume, iSCSI-TestVolume, with the host port IQN set to :server01.īest Practice: For best performance out of a single host, eight (8) iSCSI sessions are recommended.Select the checkbox next to the iSCSI-TestVolume (or whatever volume name was created), then click Connect. The Connect Volumes to Host dialog will open.After creating the new volume click the elipsys in the Connected Volumes section and then select Connect.For this example the name iSCSI-TestVolume with a size of 500GB is being used. Click on the + in the Volumes section to create a volume.Enter the IQN from the previous section then click Add. The Configure iSCSI IQNs dialog box will open.Select the newly created host, Server01, then click the Ellipsis on the top right, then click Configure IQNs.Click on the + in the Hosts section and select Create Host.Open the Pure Storage FlashArray Management interface and log into the FlashArray.if a volume is not connected, you will receive an Authorization Failure. Connecting a volume to a configured iSCSI host on the Pure Storage FlashArray is required before configuring MSiSCSI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |